Description Of The Device; Features - EuroLite TMH XB-200 Bedienungsanleitung

For overhead use (mounting height >100 cm), always fix the fixture with an appropriate safety-rope. Fix the
safety-rope at the correct fixation points only. The safety-rope must never be fixed at the transport handles!
Only operate the fixture after having checked that the housing is firmly closed and all screws are tightly
fastened.
The lamp must never be ignited if the objective-lens or any housing-cover is open, as discharge lamps may
explode and emit a high ultraviolet radiation, which may cause burns.
The maximum ambient temperature T = 45° C must never be exceeded.
a
Operate the device only after having become familiarized with its functions. Do not permit operation by
persons not qualified for operating the device. Most damages are the result of unprofessional operation!
Please use the original packaging if the device is to be transported.
Please consider that unauthorized modifications on the device are forbidden due to safety reasons!
Never remove the serial barcode from the device as this would make the guarantee void.
If this device will be operated in any way different to the one described in this manual, the product may suffer
damages and the guarantee becomes void. Furthermore, any other operation may lead to dangers like short-
circuit, burns, electric shock, lamp explosion, crash etc.

DESCRIPTION OF THE DEVICE

Features

High-Power Beam for OSD 5 Reflector 200W discharge lamp
• Very narrow beam angle with 2°
• With electronic ballast
• Color wheel with 13 different dichroic color filters plus white
• Switchable color change (mode 1: only full colors, mode 2: half colors)
• Rainbow effect with adjustable speed
• 8-facet prism
• Frost-filter
• Gobo wheel with 13 static gobos plus open
• With gobo shake function
• Motorized focus
• Strobe effect with adjustable speed
• Random strobe effect
• Dimmer
• Exact positioning via 16 bit PAN/TILT movement resolution
• Automatic position correction
• Switch-mode power supply for operation between 100 and 240 volts
• Control board with graphic LC display and encoder for adjusting the DMX-starting address, PAN/TILT
reverse, reset, lamp on/off, operating hours
• DMX-controlled operation or stand-alone operation with master/slave function
• For OSD 5 Reflector 200W discharge lamp
• Power connection via Neutrik PowerCon socket and included power cable
• DMX-control via every standard DMX-controller
25/38 00094283.DOC, Version 1.0