AEG BE8615001 Benutzerinformation Seite 28

28 www.aeg.com
• To clean metal surfaces use a usual
cleaning agent.
• Clean the oven interior after each use.
Then you can remove dirt more easily
and it does not burn on.
• Clean stubborn dirt with a special
oven cleaner.
• Clean all oven accessories after each
use and let them dry. Use a soft cloth
with warm water and a cleaning agent.
• If you have nonstick accessories, do
not clean them using aggressive
agents, sharp-edged objects or a dish-
washer. It can destroy nonstick coat-
ing.
Stainless steel or aluminium ap-
pliances:
Clean the oven door with a wet
sponge only. Dry it with a soft
cloth.
Do not use steel wool, acids or
abrasive materials, as they can
cause damage to the oven sur-
face. Clean the oven control pan-
el with the same precautions.
Removing the shelf supports
Installing the shelf supports
Install the shelf supports in the opposite
sequence.
2
1
12.1 Cleaning the door gasket
• Regularly do a check of the door gas-
ket. The door gasket is around the
frame of the oven cavity. Do not use
the appliance if the door gasket is
damaged. Contact the Service Centre.
• To clean the door gasket, refer to the
general information about cleaning.
12.2 Shelf supports
You can remove the shelf supports to
clean the side walls.
1. Pull the front of the shelf support
away from the side wall.
2. Pull the rear end of the shelf sup-
port away from the side wall and re-
move it.
The rounded ends of the shelf
supports must point to the front.