Invert The Chaser-Direction - EuroLite DMX Scene Setter 24/48 Bedienungsanleitung

If the chaser is to be run exactly in the bass-beat, pull Speed-fader to minimum (the display shows "Sho")
and enter the bass-beats by pressing the Tap Sync-button repeatedly.
If the chaser is to be run step by step, pull Speed-fader to minimum (the display shows "Sho") and press the
Step-button repeatedly.
Memorize/edit chaser-speed
With the Scene Setter, you can run several chasers at a time in the Mix Chase-mode and define and
memorize an individual chaser-speed for every chaser.
Press the Audio-button, the LED turns off. Press the Park-button until the Mix Mode-LED is lit. Select the
desired chaser via the faders in Preset B. Adjust the desired speed via the Speed-fader or the Tap Sync-
buttons. Press and hold the Rec Speed-button and press the respective Flash-button in Preset B in order to
memorize the speed.
Delete a memorized chaser-speed
Press the Audio-button, the LED turns off. Press the Park-button until the Mix Mode-LED is lit. Set the
Speed-fader to minimum position (Show). Press and hold the Rec Speed-button and press the respective
Flash-button in Preset B in order to delete the memorized speed.
Switch the speed-range
The speed-range can be switched from 5 minutes to 10 minutes:
Press and hold the Record-button.
Press the Flash-button 10 in Preset A three times.
Release the Record-button.
The 10MIN-LED is lit and the right scale is activated.
The speed-range can be switched from 10 minutes to 5 minutes:
Press and hold the Record-button.
Press the Flash-button 5 in Preset A three times.
Release the Record-button.
The 5MIN-LED is lit and the left scale is activated.

Invert the chaser-direction

Press the Chase Rev-button.
The chaser-direction is inverted.
Delete a step in a chaser
Press the Mode Select-button, until the Chase/Scenes-LED is lit.
Pull all channel-faders to minimum.
Push the Master A-fader to maximum.
Hold the Edit-button and press the chaser's Flash-button in Preset B.
The chaser will be called up.
Pull the Speed-fader to minimum.
Press the Step-button in order to call up the desired step.
Press the Delete-button in order to delete the step.
Press and hold the Record-button and press the Rec Exit-button in order to leave the editing mode.
Add a step to a chaser
Press the Mode Select-button, until the Chase/Scenes-LED is lit.
Pull all channel-faders to minimum.
Push the Master A-fader to maximum.
Hold the Edit-button and press the chaser's Flash-button in Preset B.
23/27 70064545_V_1_4.DOC