Problem Chart; Cleaning And Maintenance; Technical Specifications - EuroLite DMX Scene Setter 24/48 Bedienungsanleitung

Press the Flash-button 3 in Preset A three times.
Release the Record-button.
When the display will show In, the controller is ready for receiving the dump.
When receiving the dump, all other functions are switched off. As soon as the transmission is complete or
cancelled due to errors, the controller returns to normal operation mode.
Send a Sys-Ex dump
Press and hold the Record-button.
Press the Flash-button 4 in Preset A three times.
Release the Record-button.
When the display will show Out, the controller is ready for sending the dump.
When sending the dump, all other functions are switched off. As soon as the transmission is complete or
cancelled due to errors, the controller returns to normal operation mode.

7. PROBLEM CHART

PROBLEM
No power.
Display shows LOP.
Cannot memorize Scene.
Cannot edit programs.
Programmed scene/chaser
disappeared.
Cannot display
scene/chaser.
No signal output.

8. CLEANING AND MAINTENANCE

We recommend a frequent cleaning of the device. Please use a soft lint-free and moistened cloth. Never use
alcohol or solvents!
There are no servicable parts inside the device. Maintenance and service operations are only to be carried
out by authorized dealers.
Should you need any spare parts, please use genuine parts.
Should you have further questions, please contact your dealer.

9. TECHNICAL SPECIFICATIONS

Power supply:
CAUSE
The power unit is not connected.
Operating volatage is too low.
Record-button forgotten.
Program mode locked.
Selected wrong page.
Wrong fader-setting.
Blackout-mode activated.
DANGER TO LIFE!
Disconnect from mains before starting maintenance operation!
230 V AC, 50 Hz ~
Check the connection cable of the
power unit and any extension-cables.
Check the connection cable of the
power unit and any extension-cables.
Press the Record-button after setting
the channels.
Unlock program mode.
Select correct page via the Page-
button.
Adjust Master-fader to maximum, the
Fade-fader and Speed-fader to the
desired setting.
Switch off blackout by pressing the
Blackout-button.
26/27
REMEDY
70064545_V_1_4.DOC