Description Of The Device; Features; Installation; Danger Of Fire - EuroLite LED BCW-4 Strahleneffekt Bedienungsanleitung

DESCRIPTION OF THE DEVICE

Features

Unique color changing lighting effect

Clear, faceted surface provides for unique beam effects, including integrated fancy color changing wall
light

The upper light effect dome is equipped with 3 bright 1 W LEDs in red, green and blue and the ring
below comprises 48 RGB 5 mm LEDs

2 independent sound control systems via 2 built-in microphones: a rotating light design develops from
the dome which changes its direction and colors with every bass beat and the ring features several
internal programs in a continuous loop which change direction as well as sequence with every base beat

For wall mounting

Ready for connection via power cord with Euro plug

Switch-mode power supply allows automatic power supply adaption between 100 and 240 Volts without
power selector

INSTALLATION

When installing the device, make sure there is no highly-inflammable
material (decoration articles, etc.) within a distance of min. 0.5 m.
The device can be installed on the wall or ceiling.

Attachment

Before attaching the device, make sure that the installation area can hold a minimum point load of 5 times
the device's weight.
The device must only be installed absolutely planar at a vibration-free, oscillation-free and fire-resistant
location. Make sure that the device is installed absolutely planar by using a water-level.
The device must be installed out of the reach of people.
The device must always be installed via all fixation holes. Do only use appropriate screws and make sure
that the screws are properly connected with the ground.
The durability of the installation depends very much on the material used at the installation area (building
material) such as wood, concrete, gas concrete, brick etc. This is why the fixing material must be chosen to
suit the wall material. Always ask a specialist for the correct plug/screw combination indicating the maximum
load and the building material.
Procedure:
Step 1: On the baseplate, there are the holes for the installation.
Step 2: Hold the baseplate onto the location where the device is to be installed.
Step 3: Mark the boreholes with a pen or a suitable tool.
Step 4: Drill the holes and screw the appropriate screws into the installation surface until almost plane.
Step 5: Hold the baseplate in the desired position and hang it onto the screws.
Before taking into operation for the first time, the installation has to be approved by an expert!

DANGER OF FIRE!

DANGER TO LIFE!

12/13 00082141.DOC, Version 1.0