5. SETUP
5.1 Installation
Install the device on a plane surface.
Connect the connection cable of the power-unit with the DC IN-socket. Plug the power unit into your outlet.
5.2 Sound-control
The sound-control works via the Line In socket. Connect the sound-signal from the mixer (e.g. Master 2) with
the RCA-socket on the rear panel (input sensitivity 0.1 V - 1 V).
5.3 Connection with the dimmerpacks
DMX-512:
The wires must not come into contact with each other, otherwise
the fixtures will not work at all, or will not work properly.
Only use a stereo shielded cable and 3-pin XLR-plugs and connectors in order to connect the controller with
the fixture or one fixture with another.
Building a serial DMX-chain:
Connect the DMX-output of the SCENE SETTER with the DMX-input of the nearest dimmerpack. Always
connect one output with the input of the next fixture until all fixtures are connected.
Ω
Caution: At the last fixture, the DMX-cable has to be terminated with a terminator. Solder a 120
resistor
between Signal (–) and Signal (+) into a 3-pin XLR-plug and plug it in the DMX-output of the last fixture.
5.4 Connecting the smoke-machine
You can connect analogue-controlled smoke-machines to the smoke-machine socket.
The pin occupation of the smoke-machine socket is as follows:
Between L – earthing = operating voltage smoke-machine
N = Switching contact for the pump
6. OPERATION
After you connected the device to the mains, the DMX Scene Setter is ready for use.
Unlock program mode
Before you can start programming you need to unlock the program mode.
Press and hold the Record-button.
Press the Flash-buttons 1, 6, 6, 8 in Preset A.
Release the Record-button.
The red LED above the Record-button is lit again and the program mode is unlocked.
2 x 24 channel Preset
With the Scene Setter you can adust two different scenes in Preset A and Preset B and fade from one to
another via the master-faders.
Press the Mode Select-button, until the A Double/Preset B-LED is lit.
21/27
70064545_V_1_4.DOC