Call Up Several Chasers Continuously; Invert The Chaser-Direction; Sound-Control; Delete A Program - EuroLite FD-4 DMX-Controller Bedienungsanleitung

6.7 Call up several chasers continuously

The programs and chasers can be called up individually or combined.
Press all Chaser-buttons and Program-buttons so that their LEDs are lit.
Adjust Masterfader for total output.
Adjust Speed-Fader until the spots react in the desired speed.
The running order is CH1-2-3-4-PR-1-2-3-4. Empty programs will be ommitted.

6.8 Invert the chaser-direction

Press the Prog. <>-button. The Prog. <>-LED is lit. The chaser-direction is inverted.

6.9 Sound-control

If the chaser is to be run sound-controlled, press the Audio-button (LED is lit).
If the chaser is to be run exactly in the bass-beat, pull Speed-fader to minimum and enter the bass-beats by
pressing the Tap Sync-button repeatedly.

6.10 Delete a program

Press and hold the Prog. <>-button and select the desired program number via the Program-button. The
Prog. <>-LED is lit and the Program-LED flashes.
Press and hold the Tap Sync-button and the current Program-button in order to delete the program. The
LEDs flash 5 times.
Press and hold the Prog. <>-button and the current Program-button in order to leave this mode.

6.11 Set all channels to maximum

Press the Full On-button and all channels will be set to their maximum value. As soon as you release the
button, the channels return to their original setting.

6.12 Blackout-Mode

Press the Blackout-button and all devices will be set to Blackout-mode.

7. PROBLEM CHART

PROBLEM
No power.
No signal output.
Cannot program a program. The Prog. <>-LED is still lit.
Cannot program a program. The program is full.
CAUSE
The power unit is not connected.
Blackout-mode activated.
19/20
REMEDY
Check the connection cable of the
power unit and any extension-cables.
Switch off blackout by pressing the
Blackout-button.
Press the Prog. <>-button again and
the Prog. <>-LED is off.
Press and hold the Tap Sync-button
and the current Program-button in
order to delete the program.
00028596.DOC, Version 1.2