Switch The Dimmer Display; Memorize Scenes; Memorize Chasers - EuroLite DMX Scene Setter 24/48 Bedienungsanleitung

Push Master A-fader to maximum.
Push channel-faders in Preset A to the desired setting.
Pull the Master B-fader to maximum.
Push channel-faders in Preset B to the desired setting.
Fade from Preset B to Preset A by pushing Master A-fader and Master B-fader.
In Double Preset-mode, the buttons over the master faders can be used as Flash-buttons.

Switch the dimmer display

The dimmer display can be switched from percent to the DMX-value:
Press and hold the Record-button.
Press the Insert-button and the display switched to the DMX-value (0-255).
In order to switch the display back to percent, repeat the procedure.

Memorize scenes

With the Scene Setter you can memorize up to 96 different scenes with 48 channels (Page 1 to Page 4).
Press the Mode Select-button, until the 1-48 Single/Preset Park-LED is lit.
Push the Master A-fader to maximum.
Push channel-faders to the desired setting.
Press the Record-button.
Press and hold the Record-button and press the desired Flash-button in Preset B.
The scene is now memorized on this fader.
Call up scenes
Press the Mode Select-button, until the Chase/Scenes-LED is lit.
Pull all channel-faders to minimum.
Push the Master A-fader to maximum.
Push the channel-fader of the desired scene in Preset B to maximum.
The scene will be called up.

Memorize chasers

With the Scene Setter you can memorize up to 48 different scenes with 24 channels (Page 1 to Page 4).
Press the Mode Select-button, until the 1-48 Single/Preset Park-LED is lit.
Push the Master A-fader to maximum.
Push channel-faders to the desired setting.
Press the Record-button.
Push channel-faders to the desired setting for editing the next scene and press the Record-button.
Memorize as many scenes as desired or until the maximum (999 scenes) is reached.
Press and hold the Record-button and press the desired Flash-button in Preset B.
The scene is now memorized on this fader.
Call up chasers
Press the Mode Select-button, until the Chase/Scenes-LED is lit.
Pull all channel-faders to minimum.
Push the Master A-fader to maximum.
Push the channel-fader of the desired chaser in Preset B to maximum.
The chaser will be called up.
Run a chaser
Adjust the desired fade-time via the Fade-Fader.
Adjust the desired chaser-speed via the Speed-fader.
If the chaser is to be run sound-controlled, press the Audio-button and adjust the desired sensitivity via the
Audio-fader.
22/27 70064545_V_1_4.DOC