SOLIS BARISTA TRIPLE HEAT 1011 Bedienungsanleitung Seite 75

CON D UCT IN G A CL EA N IN G CY CLE
■ ▲
Through regular use, residues of coffee powder and coffee oil form in the appliance,
impairing the brewing process. Therefore, you should conduct a cleaning cycle after
obtaining 200 espressos, meaning every time "CLEAN ME!" is displayed.
Proceed as follows:
– Empty the drip tray and return it to the appliance. Fill the water tank up to the
MAX marking.
1. Place the rubber cover in the filter insert (for one or two cups) and the filter insert
in the portafilter.
2. Place a SOLITABS cleaning tablet (without sponge) in the filter insert, on the
rubber disk.
3. Twist and install the portafilter in the brewing head.
4. Press the MENU button until the CLEAN CYCLE text flashes and PUSH is displayed.
5. To start the cleaning cycle, press the MANUAL button.
6. The CLEAN CYCLE text flashes and 370 seconds are counted down in the display.
7. Once the count down has reached 0, switch the appliance off with the POWER
button, remove the portafilter and check if the SOLITABS tablet has completely
dissolved. Should this not be the case, repeat steps 3 to 6 until the tablet has com-
pletely dissolved. Should the SOLITABS tablet have dissolved, rinse the portafilter
and the filter insert with warm water.
– Should you encounter problems when making espresso the next time, please
refer to the section "Troubleshooting" for ideas on how to solve the problem.
– The Troubleshooting section can be found on page 156–158.
– SOLITABS cleaning tablets are available from good specialist retailers or from
Solis of Switzerland Ltd.
Telephone: 0848 804 884, Telefax: 0848 804 890
email: info.ch@solis.com or www.solis.ch
(Shipping only within Switzerland)
148
CL E ANI NG T HE S TE AM W AND
■ ▲
from wand after texturing each use
➊ ➋
The steam wand should be cleaned every time after steaming milk.
Proceed as follows:
1. Point the steam wand towards the drip tray and set the steam lever to the OPEN
position. Like this, remove potential milk residues by letting some steam escape.
Set the steam lever to the CLOSED position. Switch the appliance off with the
POWER button and let the appliance cool down.
2. Wipe the outside of the steam wand with a damp cloth.
3. If the steam wand remains blocked, use the pin on the cleaning tool to clear the
opening.
4. If the steam wand remains blocked at all, the tip of the steam wand can be re-
moved by using the spanner in the centre of the cleaning tool. Unscrew the tip.
5. Soak the tip in hot water before using the pin on the cleaning tool to unblock.
Replace the tip back onto the steam wand and secure with the spanner in the
cleaning tool.
➌ ➍ ➎
149