Deinstalling The Inverter - Steca Grid 8000 Bedienungsanleitung

EN
8.10

Deinstalling the inverter

Danger
Risk of death by electrocution! Only technical professionals may perform the work described in Sec-
tion Deinstalling the inverter. Observe the warning notes in Section 8.1, p. 57.
66
Switching off the AC and DC supplies
1. Turn the AC circuit breaker to off.
2. Set the DC circuit breaker on the inverter to position 0 (fig.
Disconnecting the DC cables from the inverter

Disconnecting the AC plug from the inverter
1. Remove the AC plug from the socket on the inverter as de-
2. Check that all pins of the AC plug are free of voltage. Use a
Opening the AC plug (only if required)

Removing the inverter from the mounting surface
6
5
4
1
3
1. Remove the screws from the fastening holes .
2. Lift the inverter  from the mounting rail   and remove it
2
left).
Disconnect the Multi-Contact MC4 connections of the DC
cables according to the manufacturer's instructions. A special
tool is required for this.
Warning: DC cables carry voltage when the solar modules
are subjected to sunlight.
scribed on p. 123 onwards.
suitable voltmeter for this (do not use a simple neon phase
checker).
Open the AC plug as described on p. 123 onwards.
Caution
Danger of personal injury. The inverter weighs 42 kg.
• Always carry the inverter using at least two people.
• Use the handle  to carry the device.
Caution
Danger from hot surfaces. Allow hot inverters to cool
down before touching.
from the mounting surface .
744.378 | 12.13