Steca Grid 8000 Bedienungsanleitung Seite 66

EN
Setting the country and reactive power characteristic curve
64
Note
The country can only be set once!
1. Press  to select a country.
2. Press SET briefly.
3. Press SET for a longer time.
If a reactive power characteristic curve is not prescribed
for the selected country then finish initial commission-
ing (see Finishing initial commissioning).
4. Press  to select the reactive power characteristic
curve according to the local regulations.
5. Press SET briefly. The characteristic curve is adopted.
6. Press SET for a longer time.
If Default char. curve was selected in step 4 then
–
continue with step 18.
If Char. curve cos φ = 1 was selected in step 4 then
–
continue with step 19.
7. Press SET briefly. The setting value flashes.
8. Press  to change the number of nodes.
9. Press SET briefly. The value is adopted.
10. Press SET for a longer time.
11. Press  to select a setting value for the first node. P%
has predefined fixed values for the first and last node
(000%, 100%).
12. Press SET briefly. The setting value flashes.
13. Press  to change the value.
14. Press SET briefly. The change is adopted.
15. Repeat steps 11 to 14 for the other setting value as
required.
16. Press SET for a longer time.
17. Repeat steps 11 to 16 for the setting values of the re-
maining nodes.
18. Press  to select the maximum overall apparent out-
put power of the system (!).
1)
Total of the maximum apparent output power values
1)
of all inverters of the system.
19. The characteristic curve is displayed graphically (example
in fig. left).
20. Press SET for a longer time.
744.378 | 12.13