Hold Function; Max. / Min. / Avg. Function - VOLTCRAFT VC650BT Bedienungsanleitung

14. HOLD FUNCTION

The HOLD function freezes the currently indicated measured value to allow you to read or record it easily.
If you test live wires make sure that this function is deactivated before the measurement starts.
Otherwise, the measurement will be incorrect!
To switch on the Hold function, press the H / LIGHT button (8); a signal sound confi rms this command
and "H" appears on the display.
In order to switch off the HOLD function, press the H / LIGHT button (8) again or change the
measurement function.

15. MAX. / MIN. / AVG. FUNCTION

The MAX/MIN function enables recording and displaying the maximum and minimum values during
measuring. When the "MAX/MIN" function is activated, either the max or min value is displayed. The
current measured value continues to be displayed in the small upper display.
By pressing the "MAX/MIN" button (6), the current measuring range is set (autorange is deactivated).
The display shows the inverse symbol "MINMAX" and "MANUAL". The currently measured value will
be displayed. The max value is shown continually on the main display. You can recognise this value
by the "MAX" symbol.
Press again to switch on the MIN function. The min value is shown continually on the main display.
You can recognise this value by the "MIN" symbol.
Press again to switch on the AVG function. The average value is shown continually on the main
display. You can recognise this value by the "AVG" symbol.
To switch off this function, keep the "MAX/MIN" button pressed for approx. 2 s. The inverse symbol
"MAXMIN" goes out and the automatic measuring range selection is activated.
The MAX-MIN function is not available for all measuring functions.
60