Measuring Lines; Starting The Measurement - VOLTCRAFT VC650BT Bedienungsanleitung

5. Close and lock the battery compartment by turning the two screws inside from the position "OPEN"
to "CLOSE".
6. Close and lock the storage compartment by turning the two screws inside from the position
"OPEN" to "CLOSE".
When the DMM is powered by batteries, the power switch (22) is disabled. To completely switch
off the DMM, slide the "DC/AC" selection switch (21) to the position "AC" and press the power
switch to "O" position.
Alternating current power
1. Slide the DC / AC selection switch (21) to the position "AC".
2. Connect the power cord (standard C13) to the power inlet (standard C14) (23) at the back of the
multimeter.
3. Connect the power plug of the power cord to a mains outlet.

10. MEASURING LINES

A pair of measurement leads and a pair of alligator clips are included. Depending on your needs,
select your desired pair of measuring leads. Insert the round end of the leads to the corresponding
jack.
If you are using the probes, touch the probes on the measuring points; If you are using the clips, clip
them on the measuring points.

11. STARTING THE MEASUREMENT

Do not exceed the maximum permitted input values.
Do not touch any circuits or parts of circuits if there may be voltages higher than 25
V/ACrms or 35 V/DC present within them! Danger to life!
Before measuring, check the connected measuring leads for damage such as, for
example, cuts, cracks or squeezing. Defective measuring cables must no longer be
used! Danger to life!
During measuring, do not grip beyond the tangible grip range markings present
on the test leads.
Only the two measuring leads that are required for measuring operation must be
connected to the meter at any time. Remove all measuring leads not required from
the device for safety reasons.
Measurements in electrical circuits >50 V/AC and >75 V/DC must only be carried
out by specialists and technically instructed personnel who are familiar with the
relevant regulations and the ensuing risks.
52