PeakTech 3131eff Bedienungsanleitung Seite 14

5.1. Battery Installation or replacement
The meter is powered by two 1.5 V Alkaline batteries. Refer to
Fig. 4 and use the following procedure to replace the battery.
1. Disconnect the test leads and turn the meter off. Remove the test
leads from the front terminals.
2. Remove the battery cover of case bottom from the instrument by
removing the screw and then lifting off battery cover.
3. Lift the battery from the battery box.
4. Reinsert the battery into the battery box.
5. Replace the battery cover and reinstall the screw.
Caution!
Batteries, which are used up dispose duly. Used up batteries are
hazardous and must be given in the for this being supposed collective
container.
All rights, also for translation, reprinting and copy of this manual or
parts are reserved.
Reproductions of all kinds (photocopy, microfilm or other) only by
written permission of the publisher.
This manual considers the latest technical knowing. Technical
changings which are in the interest of progress reserved.
We herewith confirm that the unit is calibrated by the factory according
to the specifications as per the technical specifications.
We recommend to calibrate the unit again, after 1 year.
®
©PeakTech 03/2007/Th
-27-
PeakTech
Bedienungsanleitung/
Operation Manual
Digital- AC/DC Zangenmessgerät/
Digital-AC/DC Clamp Meter
®
3131eff