Explanation Of Symbols; Intended Use - VOLTCRAFT IPC-3 Bedienungsanleitung

2. EXPLANATION OF SYMBOLS

An exclamation mark shows important notes in these operating instructions that
must be strictly observed.
The arrow-symbol indicates that special advice and notes on operation are provided.
This device is CE-compliant and meets the applicable European directives.
For use in dry indoor areas only.
Read the operating instructions carefully before commissioning.
Protection class 2 (protective insulation, double or reinforced insulation)

3. INTENDED USE

The charger is used to charge 1 to 4 round-cell rechargeable batteries. The charging slots
work independently of each other and may also be equipped with different rechargeable
battery types.
Ni-MH or Ni-Cd round cell batteries of the type A, AA (Mignon, LR6), AAA (Micro, LR3), Baby
(C), sub-C and Li-ion round cell batteries of the type CR -123A, 10440, 14500, 16340, 16650,
17355, 17500, 17670, 18490, 18500, 18650, 22650, 26500 or 26650 can be inserted.
The micro-processor-controlled charger has a single slot monitoring, charge end recognition
(minus delta-V for Ni-Cd/Ni-MH and 4.2 V for Li-Ion) and a maintenance charge function for Ni-
Cd and Ni-MH rechargeable batteries. The cell voltage of Li-Ion rechargeable batteries is moni-
tored. The rechargeable batteries will be charged fully again when it drops below 4.0 V. Li-Ion
rechargeable batteries are charged with a pre-set standardised CC/CV charging programme.
The charger has various charging and discharging programmes as well as test functions
integrated that can be used to inspect and condition the rechargeable battery. The two outer
charging slots can be used with increased charging current at individual or concurrent use.
Batteries of size Baby (C) or batteries with the same diameter must be inserted into the two
outer charging slots.
23