Connecting To A Satellite Dish; Connecting A Fixed Satellite Dish To Your Receiver; Connecting A Dish On A Motorized Positioner To Your Receiver; Connecting To A Ci Module - Strong srt 4356 pvr Bedienungsanleitung

Part 1 • English

3.2 Connecting to a satellite dish

3.2.1 Connecting a fixed satellite dish to your receiver (Please see inside cover
Figure 10)
Make your choice of satellite from which you want to receive your TV/Radio
channels.
Have your Strong dealer align your dish at the requested satellite.
Connect a coaxial cable to your LNB.
Connect the other end directly to the LNB IN connector of your receiver.
3.2.2 Connecting multiple fixed dishes to your receiver using a DiSEqC1.0
switch (Please see inside cover Figure 11)
If you want to watch programs from more than one satellite (For instance from Astra
and from Hot Bird) it is advisable to use fixed dishes and a DiSEqC 1.0 switch.
Have your Strong Dealer aim the dishes at the requested satellites.
Connect the LNB's with coaxial cables to the IN connectors of the DiSEqC 1.0
switch.
Connect the OUT connector of the DiSEqc 1.0 switch to the LNB IN connector at
the back of your receiver.
3.2.3 Connecting a dish on a motorized positioner to your receiver. (Please see
inside cover Figure 12)
Another possibility of watching programs from multiple satellites is by mounting a dish
to a motorized DiSEqc 1.2 positioner.
Have your Strong dealer mount the dish to the positioner with the correct azimuth
angle of elevation and let him set the center point for your positioner.
Connect the LNB with a coaxial cable to the LNB IN connector of the positioner.
Connect the OUT connector of the positioner to the LNB IN connector at the back
of your receiver.

3.2.4 Connecting to a CI module

Insert CI module to into CI slot for watching TV programs from a service provider.
Note: Do not plug in/out CI module when the receiver is powered on You can
insert a smart card to CI module when it is powered on.
www.strongsat.com

4.0 Starting up

Ensure that your satellite receiver is correctly connected to your television and dish
and that your satellite signal is of good quality. (If you are not sure about this then ask
your local Strong dealer to check your installation or satellite signal).

4.1 Starting up for the First Time:

When you first start up, the language menu will be displayed. The default language of
the On Screen Menu is set to English, to choose another language refer to "Language
settings" in the manual (Chapter 5.1.4.1 ).

5.0 Basic settings

Note: Every time the receiver asks you to put your PIN code, enter '1234' on your
remote control using [0-9] numeric keypads.
Remember: To switch between the TV/Radio channels list, you will have to press the
TV/Radio buttons on your remote accordingly.
5.1 Main Menu (Please see inside cover Screen 1)
All the important settings and features of your receiver can be operated from the Main
Menu. The Main Menu consists of several sub-menus such as "Channel Organizer",
"Favourite Organizer", "Timer", "Personal recorder", "Installation ", "Games" and
"Common Interface". To display and navigate through the main menu of the receiver
please apply the following steps:
1. Press the Menu button.
2. Use UP/DOWN keys, to navigate through the menu.
3. Press OK button every time you select an item from the menu.
4. Press the Exit button to terminate an operation.
5. Press tile Exit button until you go back to main menu.
Tip: Always read the Help bar displayed at the bottom of your screen.

5.1.1 Channel Organizer Menu

Tile "Channel Organizer" menu enables you to sort channels, make your own
Favourite channels list, edit channel names and delete channels from the list.
13 14
Part 1 • English
www.strongsat.com