Safety Precautions; Storage; Equipment Set-Up; Your Receiver - Strong srt 4356 pvr Bedienungsanleitung

Part 1 • English
Remote Control Unit
2x Batteries (AAA type)
Note: The batteries should not be recharged, disassembled, electrically
short-circuited or be mixed or used with other types of batteries.

1.3 Safety Precautions

To maintain your receiver's optimum performance, you are advised to apply the
following safety precautions:
Read this manual carefully and make sure you fully understand the instructions
given.
Before starting any maintenance or installation procedures, disconnect the
receiver from the power mains.
If you wish, you may clean your receiver with a soft lint-free cloth slightly made
damp with a mild soap solution.
Do not use alcohol or ammonia based liquids to clean the receiver.
Do not open the receiver cover, as you will be exposed to a shock hazard
Do not open the receiver cover this will void your warrantee.
Do not place any objects on top of the receiver because this might prevent proper
cooling of the components inside.
Make sure no foreign objects fall through the ventilation slots because this could
cause fire or an electric shock.
Wait a few seconds after switching off the receiver before you move the receiver
or disconnect any equipment;
Please ensure that that the electrical power supply corresponds with the voltage
on the electrical identification plate at the back of the receiver.
It is a necessity that you only use an approved extension and compatible wiring
that is suitable for the electrical power consumption of the installed equipment.
If the receiver does not operate normally even after strictly following the
instructions in this user manual, it is recommended to consult your dealer.

1.4 Storage

Your receiver and its accessories are stored and delivered in a well protective
www.strongsat.com
packaging against electric shocks and moisture. When unpacking it, make sure that all
the parts are included and keep packaging away from children. When transporting the
receiver from one place to another or if you are returning it under warrantee make sure
to store the receiver in its original packaging with its accessories. Failing to comply
with such packaging procedures could void your warrantee.

1.5 Equipment Set-up

We recommend you to consult a professional installer to set up your equipment.
Otherwise, please follow the following instructions:
Refer to the user manual of your TV and dish.
Make sure that the UHF coaxial cable is in a good condition.
Make sure that the UHF coaxial cable connections are well shielded
Make sure that the outdoor components of the dish are in good condition.
Make sure that the dish is aimed at the satellite of your choice.
Make sure that the dish is connected with the correct RF coaxial cable (75 Ohm)
and is in good condition.

2.0 Your Receiver

2.1 Front Panel (Please see inside cover Figure 1)
1. Power Button
Turns the receiver On/Off
2. Stand-by / Power on (2 LED)
The red LED is the "stand-by" indicator. The green LED is the "Power On" indicator.
3. LEFT/RIGHT Buttons
Increases/decreases the volume levels in No-menu state. Moves the cursor
LEFT/RIGHT in Menu state.
4. UP/DOWN Buttons
Move the cursor UP/DOWN in Menu state. Changes the current program to the
previous/next program in No-menu state.
5. Menu/Select Button
Shows the set-up menu in No-menu state. In the Menu State it activates the
5 6
Part 1 • English
www.strongsat.com