Trouble Shooting - Strong srt 4356 pvr Bedienungsanleitung

Part 1 • English
Records the current program
A.1 Trouble Shooting
Occasionally receivers can hang-up (just like with PC) so you are recommended to
reset the receiver by disconnecting it from mains power. Wait 30 seconds and connect
to mains power again and now check if the unit is working as expected. If the receiver
does not work property after checking the trouble shooting section, please contact the
dealer. Don't open the receiver cover, it may cause an electrical shock due to high
current voltage and the warrantee of your receiver will be void if the receiver has been
opened.
Symptoms Cause
The green/red lights The power cord is not
on front panel do not plugged in.
light up.
No picture and sound TV is set to
Channel.
No picture and sound. Problem in
connections
receiver and TV
No picture and sound Receiver "hang-up"
No sound The receiver or TV is in
"MUTE" mode
No sound or picture Problem in scart cable
connections
www.strongsat.com
Solution
Check that the power cord is plugged
into the wall outlet.
wrong Check if the TV is switched on and set
your TV to the correct EXT/AV or UHF
cbannel.
cable Check if the scart and/or RF cable is
between connected correctly to the TV and to
the back of the receiver.
Switch off receiver; disconnect the main
power cord of the receiver from the
220V main power, After 30 seconds
reconnect to the main power and check
if it is working properly.
Press file MUTE button on the remote
control unit of your receiver and TV.
Firmly press the scart connectors or the
between backside of the TV and receiver
The receiver displays
the message ' No or
Bad signal"
The receiver displays
the message ' No or
Bad signal"
The receiver displays
the message No or
Bad signal"
The RED and Green
lights on
panel of your receiver
are blinking
The remote control is
not working,
37 38
receiver and TV Replace the scart cable
Wrong satellite selected in Press the SAT button on the RCU and
the menu. select the correct satellite
Wrong parameters set in Check settings in LNB- and Channel set
the menu. up menu.
Wrong alignment of the Ask your dealer to check the outdoor
dish. unit and antenna cable to LNB
Overload of the maximum Disconnect the 220V main power and
the front available LNB power. ask your dealer to check the LNB cable.
(Short circuit in the LNB
cable)
The batteries of the remote Check
control are not inserted or inserted correctly in your remote
exhausted, control. Check the batteries, and if they
are exhausted, replace them.
Part 1 • English
whether the batteries are
www.strongsat.com