Games; Common Interface; Personal Video Recording; How To Record - Strong srt 4356 pvr Bedienungsanleitung

Part 1 • English
5.1.5 Games (Please see inside cover Screen 22)
If you want to play a game, apply the following steps:
1. Press the menu button on your remote.
2. Using UP/DOWN keys on your remote, select "Games" and press OK.
3. Using UP/DOWN keys on your remote, select the game you want to play and
press OK.
Tetris (Please see inside cover Screen 23)
1. Enter the level (1-15) you want to play using the [0-9] numeric keypads and press
OK. The game will start automatically.
2. Left/Right button: Move the block to the left or right direction
3. Down button: Makes the block Drop
4. OK: Rotates the block
5. Press the Exit button to stop the game.
Snake (Please see inside cover Screen 24)
1. Press any button to start the game
2. Left/Right button: Move snake to a left or right direction.
3. UP/DOWN: Move snake to up or down direction.
4. If the snake eats a green square, the snake grows.
5. If the snake hits a red square, the game is over and the game will automatically
come up with a new game screen.
6. Press the Exit button to stop the game.
Sokoban (Please see inside cover Screen 25)
1. Use Up/Down, Left/Right buttons to move icon of longshoremen.
2. Your task is put to put all balls in the right places.
3. Use Red button to restart level
4. Use Blue button to Undo
5. Use Green button to return to previously level
6. Use Yellow button to go to the next Level
www.strongsat.com
5.1.6 Common Interface (Please see inside cover Screen 26)
Insert a Common interface Module (CAM) in one of the two Common Interface Slots,
situated behind the lid at the front of your receiver.
1. Press the menu button on your remote.
2. Using UP/DOWN keys, select "Common Interface" and press OK.
3. Select the position of the slot you have put your CAM in, Top or Bottom, and press
OK.
4. The receiver will display the message "Wait!" while it is initializing the CAM.
5. If the message disappears, the CAM is ready for use.
6. Press the Exit button until you go back to the main menu
ON SCREEN CHANNEL INFORMATION (Please see inside cover Screen 27)
When you start up your receiver, or when you are changing channels, there will be an
information banner at the top of your screen for a few seconds, showing you the
information about the channel you selected. When you are watching TV you can call
for this information by pressing the FUNC button. The banner at the bottom of the
screen will appear if you press the FUNC button twice, and will give you information
about the satellite and the signal strength.
6.0 Personal Video recording (PVR)
This section describes the functions used to record programs on your receiver's Hard
Disk Drive (HDD).

6.1 How to Record

There are three methods of recording programs on your HDD:
l. Normal Recording: You can view a program and record it at the same time.
2. Timer Recording: You can automatically set the starting and ending time for
recording of the desired channel.
3. TimeShift Recording: When you get interrupted from watching a program, you
can replay the missed part of the program.
By default, the recorded filename would be the same as the EPG event's name.
If EPG is not present, the recorded filename would be the same as the current channel
name.
29 30
Part 1 • English
www.strongsat.com