Zoom Mode - Metz Mecablitz 52 AF-1 Sony digital Bedienungsanleitung

• the camera's exposure metering system is
switched off...
...switched to stand-by mode, (Auto-OFF) to
save energy and to protect the power source
from unintentional discharging. The active
automatic unit switch-off is shown in the
INFO display. The flash ready indicator
the indicators on the LC display disappear.
The
mode.
The most recently used operating setting is
retained after automatic shutdown and is
immediately restored when the camera is
switched on.
The flash unit can be turned on again by
pressing the
the shutter release (wake-up function).
+
In slave-/ servo mode, the automatic cut-off
k
is not activated.
The flash unit should always be turned off
using the main switch
to be used for an extended period!
If necessary, the Auto OFF function can be set
to occur after 1 minute of inactivity, or can be
deactivated.
The flash unit switches off completely about
1 hour after its last use.
148
D
button flashes red in stand-by
D
button, or by tapping on
if it is not going
Setting the automatic unit switch-off
• Switch on the flash unit with the
and
• Press the
• Press the
• Press the

ZOOM MODE

STANDBY
• Press the
MOD.LIGHT
• Tap the sensor button on the touch display
Off
The
mode.
button. The start screen appears. The flash
unit always switches on afterwards with the
mode of operation that was used last
(e.g. manual flash mode M).
D
button as often as it takes
for the selection menu to appear.
OPTION
sensor button on the
touch display.
sensor buttons on the
touch display and select „STANDBY".
STANDBY
sensor button on the
touch display.
for the desired time. The setting is adopted
immediately. The operation display appe-
ars after about 10 seconds, or press the
button repeatedly until the operation
display appears.
D
button flashes red in stand-by
D