Pre-Flash Suppression Or Synchronisation Settings; Servo Mode Partial Light Output Settings - Metz Mecablitz 52 AF-1 Olympus digital Bedienungsanleitung

10.4.2 Pre-flash suppression or
• Set the camera to TTL mode.
• Press the sensor button
SYNC
M-SERVO
Z
24 mm
OOM
INFO P
• Press the sensor button on the touch
SYNC
If the synchronisation set here does not work
Learn
properly, then proceed as described in
10.4.4.
k
154
synchronisation settings
SYNC
touch display as many times as it takes
for the display for selecting the type of
synchronisation.
display:
synchronisation without pre-flash
synchronisation with pre-flash
The mode of operation is adopted
M-SERVO
on the
Z
24 mm
OOM
INFO
1/1
-1
1/1 /
3
1/8 -2 /
3
1/16
-1
1/16 /
3
M-SERVO
Z
35 mm
OOM
INFO 1/16
10.4.3 Servo mode partial light output
settings
SYNC
• Press the sensor button
output on the touch display as many times
as it takes for the partial light output
display to appear.
P
• Press sensor buttons
touch display and set the desired partial
light output to 1/1, 1/2, 1/8 or 1/128.
• Press the sensor button on the touch
display for the selected partial light output
1/16
(e.g. (z.B. 1/16).
The partial light output is adopted.
SYNC
Once the slave flash units have achieved
flash-readiness, the AF measurement flash
flashes.
Slave groups and remote channels cannot be
set in SERVO mode.
The camera flash unit may not work in the
remote mode
P
for partial light
on the