Automatic High-Speed Synchronisation ( Fp) - Metz Mecablitz 52 AF-1 Olympus digital Bedienungsanleitung

• Press the sensor button on the touch
1/16
display for the selected partial light output.
1/16 -1 /
3
1/16 -2 /
3
The setting is immediately effective and
automatically saved.
The distance display is adjusted to the partial
light output automatically (see 5.2).
7.4 Automatic high-speed
synchronisation ( FP)
Various cameras support automatic
high-speed synchronisation (see the
camera's operating instructions). This flash
mode makes it possible to use a flash unit
even with shutter speeds that are faster than
the flash sync speed.
Interesting results may by achieved in this
mode when, for example, a wide open
aperture (e.g., f/2.0) is used to limit the
depth of field in portrait shots taken in very
bright ambient light. The flash unit supports
high-speed synchronisation in TTL and M
flash modes.
For physical reasons, however, high-speed
synchronisation significantly reduces the
number and the maximum flash range!
Be sure to note, therefore, the flash range
on the display of the flash unit. High-speed
synchronisation is activated automatically if
a shutter speed faster than the flash sync
speed is set on the camera, whether
manually or automatically by the exposure
program.
Note that in the case of high speed synchro-
nisation the guide number of the flash unit
also depends on the shutter speed.
The faster the shutter speed, the lower the
guide number!
Setting the mode of operation
• Switch on the flash unit with the
button. The start screen appears.
Thereafter, the flash unit always switches
on with the mode of operation that was
used last (e.g. TTL flash mode).
• Tap the shutter release to transfer data
between the flash unit and the camera.
• Press the sensor button of the displayed
TTL
mode of operation on the touch display as
-7,9 m
0,7
many times as it takes for the display for
selecting the mode of operation to appear.
m
Z
F4.0
35
OOM
m
EV • Press the
INFO
touch display and select
TTL
TTL FP
• Press the
touch display.
M
The setting will take effect immediately.
sensor buttons on the
TTL FP
.
TTL FP
sensor button on the
145
k