Herunterladen Inhalt Inhalt Diese Seite drucken

Troubleshooting - Metz Mecablitz 52 AF-1 Olympus digital Bedienungsanleitung

Vorschau ausblenden Andere Handbücher für Mecablitz 52 AF-1 Olympus digital:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1

16 Troubleshooting

Should the flash unit fail to function properly
or meaningless content appear on the flash
unit display panel, switch the flash unit off
with the main switch
for approximately
10 seconds. Check the camera settings
and make sure the foot of the flash unit is
mounted correctly in the camera's accessory
shoe.
Replace the batteries with new or freshly
charged batteries!
The flash unit should function normally again
once it is switched back on. If this is not the
case, contact your local dealer.
Below is a list of some of the problems that
may occur when the flash unit is used.
For each item, possible causes and remedies
for the problem are listed.
No maximum flash range indication appears
on the display panel.
• There has been no exchange of data bet-
ween the flash unit and the camera.
Tap the camera's shutter release.
• The reflector is not in normal position.
The AF measuring beam of the flash unit is
not activated.
• The flash unit is not ready for firing.
• The camera is not in „Single-AF (S" mode.
• The camera supports only its own internal
AF measuring beam.
• Some cameras support the AF measuring
beam in the flash unit only with the
camera's central AF sensor. If a peripheral
AF sensor is selected, then the AF measu-
ring beam will not be activated in the flash
unit.
Activate the central AF sensor.
• The "AF BEAM" is switched off. Switch on
"AF BEAM", see 11.4.
The reflector position is not automatically
adjusted to the current zoom position of the
lens.
• The camera does not transfer data to the
flash unit
• There is no exchange of data between the
flash unit and the camera.
Tap the camera's shutter release.
• The camera is equipped with a lens without
CPU.
• The flash unit operates in manual zoom
mode „MZoom".
Switch to Auto-Zoom (see 11.2.3).
• The reflector is swivelled out of its locked
normal position.
• The wide-angle diffuser folds out from the
reflector.
• A Mecabounce is mounted in front of the
reflector.
k
167

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis