Energy Supply; Storing After Use; Charging The Battery - Silvercrest SHAZ 22.2 A1 - IAN 284657 Bedienungsanleitung

__CPE284657_Staubsauger_B6.book Seite 8 Montag, 12. Dezember 2016 8:29 20

5.2 Energy supply

• Plug the power
adapter 30 into a
suitable wall socket
and connect the pow-
er cable with the con-
31 30
nection for the pow-
er adapter 31.
The wall socket must continue to be easily
accessible after the device is plugged in.

5.3 Storing after use

The base station 25 is used as a holder for
the suction device 5 and the suction
pipe 19 and it serves as a battery charger
for the battery 32.
• After every use, hang
32
the suction device 5
and the suction
pipe 19 up in the
base station 25.
• Insert the battery 32
into the battery com-
25
partment 1. The bat-
tery can be charged
5 1
only here.
19

6. Charging the battery

NOTES:
• Fully charge the battery before using it
for the first time. This takes approx.
5 hours.
• After use, insert the battery into the bat-
tery compartment of the base station.
This ensures that the suction device will
always work at full power. The battery
is not damaged by regular charging.
8
GB
1. Plug the power
adapter 30 into a
suitable wall socket
and connect the
power cable with
31 30
the connection for
the power adapt-
er 31.
The wall socket must continue to be easily
accessible after the device is plugged in.
2. Insert the bat-
32 28
tery 32 into the bat-
tery compartment 1
until the LEDs of the
charging indica-
tor 28 are lit or start
flashing. Once all
LEDs are lit, the bat-
tery is completely
charged. With a full
1
charge, you can use
the vacuum cleaner
for approx.
20 minutes.
3. To remove the bat-
29 32
tery 32, press the
unlocking mecha-
nism 29 in the di-
rection of the LEDs
and remove the bat-
tery.
LED signals on the base station
- Lit LEDs show the current charging state.
- Flashing LEDs show the consumed por-
tion. When all LEDs are flashing, you
should charge the battery. With an in-
sufficient charge, the device will stop
working.
LED signals during operation
- Lit LEDs show the current charging state.
- Unlit LEDs show the consumed portion.
- Only the LED above Empty is flashing:
battery weak; the device will turn off
soon.