Energy Supply; Storing After Use; Charging The Battery - Silvercrest SHAZ 22.2 A1 Bedienungsanleitung

__CPE284657_Staubsauger_B5.book Seite 58 Montag, 12. Dezember 2016 8:24 20

5.2 Energy supply

• Plug the power
adapter 30 into a
suitable wall socket
and connect the pow-
er cable with the con-
31 30
nection for the pow-
er adapter 31.
The wall socket must continue to be easily
accessible after the device is plugged in.

5.3 Storing after use

The base station 25 is used as a holder for
the suction device 5 and the suction
pipe 19 and it serves as a battery charger
for the battery 32.
• After every use, hang
32
the suction device 5
and the suction
pipe 19 up in the
base station 25.
• Insert the battery 32
into the battery com-
25
partment 1. The bat-
tery can be charged
5 1
only here.
19

6. Charging the battery

NOTES:
• Fully charge the battery before using it
for the first time. This takes approx.
5 hours.
• After use, insert the battery into the bat-
tery compartment of the base station.
This ensures that the suction device will
always work at full power. The battery
is not damaged by regular charging.
58 GB
1. Plug the power
adapter 30 into a
suitable wall socket
and connect the
power cable with
31 30
the connection for
the power adapt-
er 31.
The wall socket must continue to be easily
accessible after the device is plugged in.
2. Insert the bat-
32 28
tery 32 into the bat-
tery compartment 1
until the LEDs of the
charging indica-
tor 28 are lit or start
flashing. Once all
LEDs are lit, the bat-
tery is completely
charged. With a full
1
charge, you can use
the vacuum cleaner
for approx.
20 minutes.
3. To remove the bat-
29 32
tery 32, press the
unlocking mecha-
nism 29 in the di-
rection of the LEDs
and remove the bat-
tery.
LED signals on the base station
- Lit LEDs show the current charging state.
- Flashing LEDs show the consumed por-
tion. When all LEDs are flashing, you
should charge the battery. With an in-
sufficient charge, the device will stop
working.
LED signals during operation
- Lit LEDs show the current charging state.
- Unlit LEDs show the consumed portion.
- Only the LED above Empty is flashing:
battery weak; the device will turn off
soon.