Troubleshooting - Saeco HD8924 Bedienungsanleitung

English
32
Error code
Other error codes
Problem
The machine does not
switch on
The machine is in DEMO
mode.
The drip tray is quickly
filled.
The coffee grounds
container full icon remains
displayed.
Problem
If the above solutions do not help to remove the error code icon from the
display and bring the machine back to normal working order, contact the Philips
Saeco hotline. Contact details can be found in the warranty booklet or on
www.saeco.com/support.

Troubleshooting

Cause
The machine is disconnected or
the main switch is in the OFF
position.
The standby button has been
pressed for more than 8 seconds.
This is normal. The machine uses
water to rinse the internal circuit
and brew group. Some water
flows through the internal system
directly into the drip tray.
The coffee grounds container was
emptied while the machine was
switched off.
Cause
Solution
Check if the mains cord is inserted
correctly
Make sure the main switch is set in ON
position.
Switch the machine off and then on
again using the main switch on the back
of the machine.
Empty the drip tray when the 'drip tray
full' full indicator pops up through the
drip tray cover.
Place a cup under the dispensing spout
to collect rinsing water.
Always empty the coffee grounds
container while the machine is ON. If
the coffee grounds container is emptied
while the machine is switched off, the
coffee cycle counter is not reset. In that
case, the 'empty coffee grounds
container' message will stay on the
display even though the container is not
full.
Possible solution
Perform a manual rinsing
cycle.
Remove the water tank
from the machine. Check
the water tank
compartment to check if
there are any coffee
beans on the bottom.
Remove them. Switch
the machine on and off.
Switch the machine off
and switch it back on
again after 30 seconds.
Try this 2 or 3 times.