Saeco HD8924 Bedienungsanleitung Seite 35

English
34
The machine grinds the
coffee beans, but coffee
does not come out.
The coffee comes out
slowly.
The milk does not froth.
The AquaClean filter
cannot be activated as the
tick does not appear on the
display.
The filter cannot be
activated and the machine
asks for descaling.
The grind is set too fine.
The brew group is dirty.
The coffee dispensing spout is
dirty.
The coffee exit duct is blocked.
The grind is ground too finely.
The brew group is dirty.
The coffee exit duct is blocked.
The machine circuit is blocked by
limescale.
The automatic milk frother is dirty
or not assembled or installed
correctly.
The type of milk used is not
suitable for frothing.
A filter has just been activated.
You have already replaced 8
AquaClean filters. After 8 filter
replacements you need to descale
the machine.
The filter has not been replaced in
time after the AquaClean water
filter signal started flashing.
Adjust the grinder to a coarser setting.
Clean the brew group.
Clean the coffee dispensing spout and its
holes with a pipe cleaner.
Clean the coffee exit duct with the
handle of the multifunctional tool or a
spoon handle.
Change the grinder to a coarser setting.
Clean the brew group.
Clean the coffee exit duct with the
handle of the multifunctional tool or a
spoon handle.
Descale the machine.
Clean the automatic milk frother and
make sure it is correctly assembled or
installed.
Different types of milk result in different
amounts of froth and different froth
qualities. Semi-skimmed or full-fat cow's
milk give good results.
You have to dispense at least 10 cups
(of 100ml each) before you can activate
a new filter. Be careful as you activate a
new filter, the filter counter will increase
automatically.
Descale your machine first and install the
filter.
Descale your machine first and install the
filter.