What To Do If The Descaling Procedure Is Interrupted - Saeco HD8924 Bedienungsanleitung

2
1
CALC
CLEAN
DESCALING
PHASE 1/2
20 MIN
DESCALING
PHASE 2/2
3 MIN
DESCALING COMPLETED

What to do if the descaling procedure is interrupted

6 The display reminds you to pour the descaling solution in the water tank. Fill
the water tank with fresh water up to the CALC CLEAN level indication.
Place the water tank back in the machine. Press the OK button to confirm.
- The first phase of the descaling cycle starts. The machine starts dispensing
the descaling solution at intervals.
- The display shows the descaling icon, the phase indication and the
duration. This first phase takes 20 minutes.
7 Let the machine dispense the descaling solution until the water tank is
empty.
8 The machine reminds you to rinse the water tank and fill it with water up to
the CALC CLEAN level indication.
9 Place the water tank back in the machine and press the OK button to
confirm.
10Remove and empty the container and place it back under the coffee
dispensing spout and the steam tube. Press the OK button to confirm.
11The second phase of descaling starts, which is a rinsing cycle. This phase
takes 3 minutes. The display shows the rinsing icon and the duration of the
phase.
12Wait until the machine stops dispensing water. The descaling procedure is
finished when the tick appears on the display.
13Press the OK button to exit the descaling cycle. The machine starts heating
up and performs the automatic rinsing cycle.
14Remove and empty the container.
15Clean the automatic milk frother.
16Install a new AquaClean filter in the water tank.
Tip: Using the AquaClean filter reduces the need for descaling!
Once the descaling procedure has started, you must complete it till the very
end without switching off the machine. If the machine gets stuck during the
cycle, you can exit the descaling procedure by pressing the standby button. If
this occurs, or in case of a power failure or accidental disconnection of the cord,
do the following:
1 Empty and rinse the water tank thoroughly.
2 Fill the water tank up to the CALC CLEAN level indication and switch the
machine back on. The machine will heat up and perform an automatic rinsing
cycle.
3 Before brewing any beverages, perform a manual rinsing cycle, see section
'Manual rinsing cycle'.
English
29