Preparing And Installing The Aquaclean Filter; Activating The Aquaclean Filter - Saeco HD8924 Bedienungsanleitung

English
12
AQUACLEAN
FILTER
0 / 8
Note: Replace the AquaClean filter when the filter icon starts flashing on the
display. Replace the AquaClean filter at least every 3 months, even if the machine
has not yet indicated that replacement is required.

Preparing and installing the AquaClean filter

1 Remove the AquaClean filter from its packaging. Shake the filter for about 5
seconds.
2 Immerse the AquaClean filter upside down in a jug with cold water and wait
until no more air bubbles come out.
3 Insert the AquaClean filter vertically onto the filter connection. Push the
AquaClean filter to the lowest possible point. Make sure that the filter fits
tightly and the seal is in the right position, to guarantee the best
performance.

Activating the AquaClean filter

You can install the AquaClean filter at first installation as part of the installation
procedure. If you skipped installation of the AquaClean filter at first use, you can
install it by entering the menu as described below.
1 Press the MENU/SPECIAL DRINKS button, select MENU and press the OK
button to confirm. Scroll to select 'AquaClean' filter. Press the OK button to
confirm.
- The display shows the number of AquaClean filters that have been
installed previously from 0 to 8 filters.