Cable Routing Diagram - Yamaha YZ426F/LC Fahrer- Und Wartungs-Handbuch

EC240000

CABLE ROUTING DIAGRAM

1 Hose guide
2 Brake hose
3 Fuel tank breather hose
4 Oil tank breather hose
5 Clamp
6 "ENGINE STOP" button lead
7 Sub wire harness
8 TPS (throttle position sensor)
lead
9 Neutral switch lead
0 Oil hose
A Hose holder
B CDI magneto lead
C Clutch cable
D Cylinder head breather hose
E Carburetor breather hose
F Overflow hose
CABLE ROUTING DIAGRAM
Å Pass the clutch cable through
the cable guide.
ı Pass the fuel tank breather
hose between the handlebar
and tension bar, then insert its
end into the hole of the num-
ber plate.
Ç Pass the decompression cable
and "ENGINE STOP" button
lead under the frame.
Î Pass the "ENGINE STOP" but-
ton lead along the inner side of
the decompression cable.
‰ Fasten the CDI magneto lead,
neutral switch
"ENGINE STOP" button lead
to the frame with a plastic lock-
ing tie and cut off the tie end.
2 - 21
Ï Pass the "ENGINE STOP"
button lead along the inner
side of the oil tank breather
hose.
Ì Fasten the sub wire harness
and "ENGINE STOP" button
lead to the frame with a plas-
tic locking tie and cut off the
tie end.
Ó Pass the cylinder head breather
hose along the right side of the
oil tank breather hose.
È Fasten the sub wire harness to
the frame with a plastic locking
lead and tie and cut off the tie end.
Ô Fasten the TPS lead (in the
sub wire harness) under the
frame.
SPEC