Yamaha YZ426F/LC Fahrer- Und Wartungs-Handbuch Seite 454

Å
ı
FRONT BRAKE AND REAR BRAKE
5 - 21
4. Install:
[Front]
Master cylinder kit 1
Push rod 2
Plain washer 3
Circlip 4
Master cylinder boot 5
Locknut 6
To master cylinder 7.
[Rear]
Master cylinder kit 1
Push rod 2
Circlip 3
Master cylinder boot 4
Locknut 5
To master cylinder 6.
NOTE:
Apply the brake fluid on the master cylinder
kit.
Apply the lithium soap base grease on the tip
of the push rod.
When installing the circlip, use a long nose
circlip pliers.
Å Front
ı Rear
EC5A5300
Front master cylinder
1. Install:
Master cylinder 1
Master cylinder bracket 2
Bolt (master cylinder bracket) 3
9 Nm (0.9 m · kg, 6.5 ft · lb)
NOTE:
Install the bracket so that the arrow mark a
face upward.
First tighten the bolts on the upper side of the
master cylinder bracket, and then tighten the
bolts on the lower side.
WARNING
Install the master cylinder so that the gaps
b and c between the bolt (grip cap) 4 and
push rod 5 are equal. If you make a mis-
take in the master cylinder installation
position, the brake lever may contact the
grip cap, resulting in poor brake perfor-
mance.
CHAS