Herunterladen Inhalt Inhalt Diese Seite drucken

Information On The Appliance; Units Of Measurement; Standardised Output Data; Safety - STIEBEL ELTRON WWS 20 Bedienung Und Installation

Warmwasser-wärmepumpe in splitbauweis
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

OPERATION

Safety

f This symbol indicates that you have to do something. The ac-
f
tion you need to take is described step by step.
1.3

Information on the appliance

Symbol
Meaning
Never cover the appliance
1.4

Units of measurement

Note
All measurements are given in mm unless stated oth-
erwise.
1.5

Standardised output data

Explanations to determine and interpret the specified standardised
output data
Standard: EN 16147
The output data specifically mentioned in text, diagrams and
technical datasheets has been calculated according to the test
conditions of the standard shown in the heading of this section.
Generally, these standardised test conditions will not fully meet
the conditions found at the installation site of the system user.
Depending on the chosen test method and the extent to which this
method deviates from the conditions defined in the norm shown in
the heading of this section, any deviations can have a considerable
impact. Additional factors that have an influence on the test values
are the measuring equipment, the system configuration, the age
of the system and the flow rates.
A confirmation of the specified output data can only be obtained
if the conditions applicable to the relevant test match those of the
standard shown in the heading of this chapter.
2.
Safety
2.1

Intended use

The appliance is intended for DHW heating within the application
limits detailed in chapter "Specification / Data table".
The appliance is intended for domestic use. It can be used safely
by untrained persons. The appliance can also be used in non-do-
mestic environments, e.g. in small businesses, as long as it is
used in the same way.
Any other use beyond that described shall be deemed inappropri-
ate. Observation of these instructions and of instructions for any
accessories used is also part of the correct use of this appliance.
2.2

Incorrect use

The following are not permitted:
- Heating liquids other than DHW
- Operating the appliance with an empty DHW cylinder
- Operating the appliance outside the application limits (see
chapter "Specification")
- Interrupting the power supply
www.stiebel-eltron.com
2.3

General safety instructions

Only qualified contractors should carry out the electrical work and
installation of this appliance. Qualified contractors are responsible
for adherence to all applicable regulations.
The appliance should only be operated once it is fully installed
and all safety equipment has been fitted.
WARNING Injury
!
The appliance may be used by children aged 8 and up and
persons with reduced physical, sensory or mental capa-
bilities or a lack of experience and know-how, provided
that they are supervised or they have been instructed on
how to use the appliance safely and have understood
the resulting risks. Children must never play with the
appliance. Children must never clean the appliance or
perform user maintenance unless they are supervised.
WARNING Electrocution
Contact with live components presents a threat to life.
Damage to the insulation or to individual components
may result in a threat to life.
f If there is damage to the insulation, switch off the
f
power supply and arrange a repair.
All work on the electrical installation must be carried
out by a qualified contractor.
WARNING Burns
The water in the DHW cylinder can be heated to temper-
atures in excess of 60 °C. There is a risk of scalding at
outlet temperatures above 43 °C.
f Ensure you do not come into contact with the water
f
when discharged.
WARNING Burns
Touching hot components can lead to burns.
When working on hot components, always wear protec-
tive working clothing and safety gloves.
The pipework connected to the DHW outlet of the appli-
ance can reach temperatures in excess of 60 °C.
WARNING Burns
The appliance is filled with refrigerant at the factory.
In the event of refrigerant escaping due to a leak, avoid
coming into contact with the refrigerant or inhaling the
released vapours. Ventilate the rooms affected.
CAUTION Injury
!
Never place any objects on top of the appliance. If objects
are left on the appliance, noise emissions may increase
due to resulting vibrations, and the objects could fall
and cause injury.
Material losses
!
If you disconnect the appliance from the power supply,
the operating status of the primary pump can no longer
be guaranteed.
f Never interrupt the power supply to the appliance.
f
WWS 20 |
39

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis