Units Of Measurement; Safety; Instructions, Standards And Regulations; General Safety Instructions - STIEBEL ELTRON WPM Bedienungsanleitung

INsTALLATIoN

safety

1.4

Units of measurement

Note

All measurements are given in mm unless stated oth-
erwise.
2. Safety
Only a qualified contractor should carry out installation, commis-
sioning, maintenance and repair of the appliance.
2.1

Instructions, standards and regulations

Note
Observe all applicable national and regional regulations
and instructions.
2.2

General safety instructions

We guarantee trouble-free function and operational reliability only
if original accessories and spare parts intended for the appliance
are used.
2.3

Notes

- Electrical installation must only be carried out by a recog-
nised and qualified contractor or by our customer service
engineers.
- The qualified contractor is responsible for adherence
to all applicable regulations during installation and
commissioning.
- The appliance should only be operated once it is fully in-
stalled and all safety equipment has been fitted.
- Protect the appliance from dust and dirt during building
work.
- Observe the operating limits listed in chapter "Specification".
2.4

Test symbols

See type plate on the appliance.
www.stiebel-eltron.com
3.

Appliance description

3.1

Standard delivery

- Wall mounting enclosure with pre-wired heat pump manager
- AF PT outside temperature sensor
- 3 TAF PT immersion/contact sensor
- 30 wedges for securing cables
4. Installation
4.1

Minimum clearances

a
1 Cable duct
a Optional space for front fascia or WPE heat pump extension
b Screwdriver space
f Allow sufficient space below the device to use a screwdriver. f
We recommend allowing enough space to the left or right of the
device that when you open the device you can allow the front fascia
to hang on one side or the other.
a
1
WPM | 13