Cleaning The Filter In The Base - ergoline FLAIR Series Gebrauchsanweisung

03/2017 1006293-03
– Use the scratch protection.
– Carefully lay the canopy panel in the guide.
4.12

Cleaning the filter in the base

– Remove the front panel: see page 45.
– Pull out the two outside filters to the front. Remove the middle filter via
the top.
– Moist or dry clean the filter.
Dry cleaning: Vacuum cleaner (depending on the degree of soiling)
Moist cleaning: Water and detergent, or with a dishwasher
WARNING!
The device may be damaged by moisture!
The cleaned filters must be dry before they are replaced.
– Replace the cleaned and dried filters. The two outer filters clip into place
with an audible click.
Cleaning and maintenance
Operating instructions – 55/66