Connecting A Tv With 21-Pin Scart Terminal Connections; To Change The Speaker Cable; Connecting The Antenna Terminals; Connecting The Room To Room In/Out Terminals - Denon S-301 Bedienungsanleitung

Connecting Other Sources

Connecting a TV with 21-pin SCART terminal connections

• Some discs contain copy prohibit signals. If such discs are played via a VCR, the copy prohibit
system may cause disturbance in the picture.
• Set the "TV TYPE" in "VIDEO SETUP" in "SETUP" in "HELP" to comply with your TV's video
format. When the TV is PAL formated, set to PAL.

To change the speaker cable

Refer to the procedure below if you want to switch to a different speaker cable. This example
describes how to mount the "+" side cable to the connector. Mount the "–" side cable in the same
way.
q Insert the included hexagonal wrench into the hole
at the side of the connector's "+" side. (Arrow A)
w Turn the hexagonal wrench in the direction of
arrow B to loosen the cable.
e Pull out the old cable. Be careful not to leave any
broken wire parts inside the connector. (Arrow C)
r Peel off the cable's sheath and insert the new
cable with the copper colored core wire twisted
tightly together into the connector. (Arrow D)
t Turn the hexagonal wrench in the direction of
Arrow E and tighten securely so that the cable cannot be pulled out. Be sure to connect both
sides of the cable to the connectors with the proper polarities.
If the polarities are inverted, the phase may be off and the bass sound may be missing, resulting
in an unnatural sound.
Monitor TV
D H
21-pin SCART terminal IN
A
C
E
D B
18
ENGLISH

Connecting the antenna terminals

• An F-type FM antenna cable plug can be connected directly.
• If the FM antenna cable's plug is not of the F-type, connect using the F-type antenna adapter
(Option).
FM outdoor antenna
Direction of
broadcasting station
FM antenna
adapter
75 Ω/ohms
(Option)
COAXIAL cable
NOTE:
• Do not connect two FM antennas
simultaneously.
• Even if an external AM antenna is used, do
not disconnect the AM loop antenna.
• Make sure AM loop antenna lead terminals
do not touch metal parts of the panel.

Connecting the ROOM TO ROOM IN/OUT terminals

These are the input/output connectors for wired remote control.
Consult your DENON dealer if you wish to use this connector.

Connecting the RS-232C terminal

This terminal is used for an external controller. Consult your DENON dealer if you wish to use this
connector.

Connecting the TRIGGER OUT terminal

• S-301 is equipped with 1 system of 12V TRIGGER OUT connections. An output can be activated
upon the selection of assigned. DVD inputs or AUX1 inputs or AUX2 inputs.
• Turn the DC 12V voltage on and off for the individual functions. (
ENGLISH
Connecting Other Sources
AM loop antenna
(Supplied)
White
Black
AM outdoor
Ground
antenna
page 57)