Handling; Care And Cleaning; Fuse Replacement; B) Cleaning - Renkforce RUCD-1804 Bedienungsanleitung

11. Handling

• If the volume inside your car is too high, you will not hear any acoustic warning signals. This constitutes a danger
to yourself and other road users. Therefore, make sure the volume is at a suitable level.
• Inattentiveness on the road may cause serious accidents. Operation of the hi-fi system may therefore only take
place if the traffic situation permits and you are not unduly distracted by operating the system.
• Do not listen to excessively loud music over an extended period of time. This may damage your hearing.

12. Care and Cleaning

Check the technical safety of the car radio regularly, e.g. for damage to the connection cables or to the casing.
If it can be assumed that safe operation is no longer possible, the device must be turned off and precautions are to be
taken to ensure that it is not used unintentionally. Disconnect the car power system!
a) Fuse Replacement
If it becomes necessary to replace a fuse, make sure that only fuses of the prescribed type and nominal current are
used (see "Technical Data").
Never repair fuses or bridge the fuse holder.
• When the power supply has been disconnected (disconnect ISO plug!) carefully remove the fuse from the fuse
holder next to the ISO plug.
• Replace it with a fuse of the same type.
• After this, you can reconnect the car radio to the board mains and take it into operation.
• Should the fuse trigger again, have the device repaired in a specialist workshop.

b) Cleaning

Clean the exterior of the device with a soft, dry cloth or brush only.
Never use any aggressive cleaning agents, cleaning alcohol or other chemical solutions, since
these may damage the casing or even impair function.
46