Getting Started; Installing The Batteries; When To Replace The Batteries - Sony RM-VZ950T Bedienungsanleitung

Getting Started

Installing the
Batteries
Slide open the battery
compartment lid and insert two
R6 (size AA) alkaline batteries (not
supplied). Be sure to match the +
and – ends on the batteries to the
diagram inside the battery
compartment.
Insert the negative (–) end first,
then push in and down until the
positive (+) end clicks into
position. When you close the
compartment lid, make sure to fix
its position first.
When to replace the
batteries
Under normal conditions, the
batteries will last up to three
months. When the batteries are
worn out, the LCD display turns
off about ten seconds after you
press any control button. When
you press a button, the LCD
display turns on, and "BATT"
appears in the display. When this
happens, replace the batteries with
new ones.
If you want to save the
batteries
The LCD display of this
Commander usually displays the
last used component name. To
save the batteries, you can also set
the display to turn off while the
Commander is not in use. See
"Turning Off the LCD (DISP)" on
page 33 for details.
Notes on batteries
• Do not mix old batteries with new
ones or mix different types of
batteries together.
• If the electrolyte inside the battery
should leak, wipe the contaminated
area of the battery compartment with
a cloth and replace the old batteries
with new ones. To prevent the
electrolyte from leaking, remove the
batteries when you plan not to use
the Commander for a long period of
time.
• The Commander still holds the
memorised settings even after you
change the batteries. To erase the
memory, see "Erasing All Memorised
Settings (DELETE)" on page 30.
5
GB