Sony RM-VZ950T Bedienungsanleitung Seite 12

Setting the Component Codes
(continued)
1
Follow Steps 2 to 6 on
pages 9 and 10 to go to the
PRESET mode.
2
Aim the Commander at the
component, and press
PROGR + or PROGR – and
1 in turn until the
component reacts as
described in the following.
Powers off: TV
Powers on: VCR, SAT, DVD,
AMP
Plays back: CD, MD, TAPE
Press PROGR + to go to the
next code number.
Press PROGR – to go back to
the previous code number.
After the numbers have
reached the highest limit, they
will start over from "000."
Each time a remote control
signal is sent,
display.
S
Tip
It is useful that you take a note of
the code number.
12
GB
appears in the
-1
3
Press the Jog dial.
"OK" appears in the display.
The code number is set, and
the Commander returns to the
Component PRESET mode.
S -1
K O
P R
S -1
V T
P R
If you want to set a code for
another component, repeat
from Step 1 to 3.
4
Select "EXIT," then press
the Jog dial to finish setting.
To cancel setup
Press SET.
Note
If you don't input anything into the
Commander for over 30 seconds
between each step, the Commander
exits SET mode.
Tips
• If you press the Jog dial at "EXIT" on
each menu, the Commander returns
to the top of the previous mode.
• If you press SET at any point during
this operation, the setup procedure
will be cancelled. Start over from
Step 1.
E S E T
E S E T