Hotkey Functions; Activating Command Mode; Selecting The Unit To Be Controlled - InfraTec Signum plus XB Handbuch

4
Operation
4.5
Hotkey Function
4.5.1

Activating Command Mode

4.5.2
Selecting the unit to be
controlled
The Hotkey function permits the operation of the Signum
from the connected console keyboard without using the buttons on the
Signum
• Activating Command Mode (
• Only for hotkey mode 3-5:
Select unit to be controlled (
• Execute hotkey function.
The following hotkey functions are available:
Function
Selecting channel directly
Selecting virtual channel
Setting brightness
Autoscan on/off
Activating the mouse manually
1)
• Only for hotkey mode 3-5:
esc
Press esc.
• Terminating Command Mode (
• Press the left
2 x
ctrl command mode. The three LEDs above the numeric keypad blink to
indicated this status.
In command mode, all inputs on the console keyboard are used for control
of the Signum
although its screen display still appears on the console monitor.
• Press F1 for hotkey mode 3,
F2 for hotkey mode 4 or
F1
F2 F3
F3 for hotkey mode 5.
The required hotkey function can be executed on the corresponding
Signum
Signum
plus
XB.
Key
1...9, A...G alphanumeric
1) 1...9, Enter numeric
F9, Num, ÷
F11
Scroll
if option is installed
ctrl key on the console keyboard twice. This activates the
plus
XB They are not sent to the connected computer,
plus
XB when the unit has been selected.
plus
plus
XB system
4.5.1 ).
4.5.2 ).
Mode
1
2 - 5
all
all
all
4.5.8 ).
XB
See
4.5.3
4.5.4
4.5.5
4.5.6
4.5.7
69