Hotkey Mode; Setting The Cascade Level - Infratec Signum Plus Xb Handbuch

4
Operation
4.4.6

Hotkey mode

hotkey mode
1:1 2:1 3:1 4:1
Hotkey mode 1 – Slave mode
Hotkey mode 2
Hotkey mode 3
Hotkey mode 4
Hotkey mode 5
4.4.7

Setting the Cascade Level

66
Hotkey mode is used to determine which keys on the local console
keyboard are available for the hotkey function (
E n t e r
• Press E to select the menu item.
NTER
The current hotkey mode is displayed for the four consoles.
M e n u
• Use the M key to change over between consoles.
ENU
• Set a hotkey mode between 1 and 5 and press Enter to confirm the
E n t e r
selection.
Enter the physical channel number via alphanumeric keys (
Virtual channel assignment for standalone units only (
Virtual channel assignment for units on level 1 (
Virtual channel assignment for units on level 2 (
Virtual channel assignment for units on level 3 (
For all modes: brightness, autoscan (
plus
The Signum XB can be operated either as a standalone unit or in a
cascaded configuration. In the latter case, the cascade level can be set to
Master (level 1) or Slave (levels 2 and 3).
In a cascaded configuration, only the first Signum
(Master). All other Signum
to the desired slave level.
Master
(level 1)
Slave
(level 2)
Slave
(level 3)
Signum
4.5 ).
4.4.5
4.4.5
4.4.5
4.5.5, 4.5.6 )
plus
XB is set to level 1
plus
XB units connected to this master unit are set
plus
XB
4.5.3 ).
4.4.5 ).
).
).
).