Normal Operating State; Changing Channel; Autoscan - Infratec Signum Plus Xb Handbuch

4
Operation
4.2
Normal Operating
State
Note
4.2.1

Changing Channel

4.2.2

Autoscan

60
When the unit is switched on, various messages appear on the LC display
before the unit reaches its normal operating state (
Displays and operation (via the pushbuttons on the front of the unit) in
basic condition refer exclusively to console connection Console 1.
• Switch to next lower channel.
• Switch to next higher channel.
The name of the active channel (if a name has been assigned
the default channel name (e.g. "Channel 1") appears on the LC display.
1:Channel 1 OK
M e n u
• Pressing the push button M
When this function is active, the Signum
pre-determined intervals to the next channel. Channels connected to PCs
which are switched off are skipped.
The user can set the dwell time on each channel and can specify which
channels are to be scanned (
• Pressing any button on the Signum
interrupts the autoscan function.
The Signum
displayed.
Signum
1:Novell
Channel Channel name
number up to 10 characters)
once activates the autoscan function.
ENU
plus
4.4.1, 4.4.2
plus
XB or any key on the keyboard
plus
XB then stays connected to the last channel which was
plus
XB
3.5).
3 OK
Power detection
OK = PC on
NS = PC off or no PC
4.4.4 ), or
XB switches automatically at
).