Plus Remote Keyboard; Supporting The Signum; Reset; Factory Settings - InfraTec Signum plus XB Handbuch

4
Operation
4.4.10

Supporting the Signum

Remote Keyboard
Remote Keyboard
1:0 2:0 3:0 4:0
4.4.11

Reset

reset Signum
4.4.12

Factory settings

factory settings
sure ???
sure ???
68
If a Signum
plus
support of this remote keyboard can be switched on and off.
E n t e r
• Select the menu item by pressing the E
The current setting for the four consoles is displayed:
M e n u
– "1" support activated
– "0" support deactivated
• Use the M
E n t e r
• Activate or deactivate support of the Signum
press E
E n t e r
• Selecting this menu item by pressing the E
Signum
After the restart, various system messages appear on the LC display before
the unit reaches its normal operating state.
All individually adjusted parameters can be reset to the factory settings. The
individual settings are deleted when this is done and must be re-entered as
required.
– Virtual channel table:
– Channel names:
– Dwell time in autoscan mode:
– Selection of channels in
autoscan mode:
– Remote Keyboard:
– Brightness:
– Hotkey mode:
E n t e r
• Select the menu item by pressing the E
• Switch to the display "YES" and confirm your selection by pressing
no
E
NTER
E n t e r
YES
Signum
plus
remote keyboard is connected to the Signum
to change over between consoles.
ENU
to confirm your selection.
NTER
plus
XB to be restarted (reset function).
completely deleted
„channel 1" ... „channel 16"
10 s
„S" (for all channels)
off (on all consoles)
100 % (for all channels)
1 – Slave mode (on all consoles)
.
plus
XB
plus
XB, the
button.
NTER
plus
remote keyboard and
button causes the
NTER
button.
NTER