Setting The Autoscan Dwell Time; Selecting Channels For Autoscan; Scan Wakeup - InfraTec Signum plus XB Handbuch

4
Operation
4.4.1
Setting the Autoscan
Dwell Time
scantime
Note
4.4.2
Selecting Channels for
Autoscan
scan channel
M e n u
4.4.3

Scan wakeup

scan wakeup
scan wakeup ON
Sets the time after which the system changes from one channel to the next
during the autoscan. This value applies for all consoles.
E n t e r
• Select the menu item by pressing the E
The current scantime (in seconds) is displayed.
scantime : 5 s
E n t e r
• Set the desired value in the range from 1 to 99 seconds and confirm the
input with the E
The burden for the console monitor increases strongly if the scantime
is too short.
A scantime of more than 10 seconds is recommended.
This menu item restricts the channels to be displayed during autoscan,
permitting individual setting of the desired system monitoring.
E n t e r • Select the menu item with the E
The current autoscan selection for all 16 channels is displayed. The display
positions from left to right correspond to the channels 1 to 16. The symbols
have the following meanings:
X = skip this channel during autoscan
SSXSSSSXAXXSSASS
S = display this channel during autoscan
A = skip channels with PCs switched off during autoscan
• Move to the desired channel module.
Channels with no channel modules installed ("–") are skipped.
• Select either skip this channel ("X" or "A") or display this channel ("S").
E n t e r
• Confirm your input by pressing E
A screen which has been blanked by the screensaver is "rewoken" when
autoscan is activated.
E n t e r
• Pres E
The wakeup function is activated or deactivated by pressing E
the active mode indicated on the LC display.
Signum
button.
NTER
NTER
NTER
to select the menu item.
NTER
plus
XB
button.
NTER
button.
.
NTER
and
63