Shutting Down; Finishing Operation; Transport; Storage - Kärcher IVS 100/75 M Z22 Betriebsanleitung

Shutting down

Switching off the device
1. Switch off the device at the main switch.
2. Pull out the mains plug.

Finishing operation

1. Switch off the device.
2. Pull out the mains plug.
3. Remove the accessory and, if necessary,
flush it out with water and allow to dry.
4. Empty the vacuum cleaner waste con-
tainer, see chapter Emptying the vacu-
um cleaner waste container.
5. On completion of wet vacuum cleaning:
a Clean and dry the filter.
b Clean the waste container with a moist
cloth and dry it off.
c Close the suction connection using
the connection bushing, see chapter
Closing the suction connection
6. Vacuum off the inside and outside of the
device and clean with a moist cloth.
Information on disposal
The following points are to be observed to
when disposing of the device, operating
materials and auxiliary materials:
 Adhere to the applicable national regula-
tions for your location
 Adhere to the company-specific regula-
tions
 Dispose of the operating materials and
auxiliary materials according to the re-
spectively applicable safety data sheets
CAUTION
Risk of injury and damage
When transporting in vehicles, secure the
device against slipping and tipping over ac-
cording to the applicable guidelines.
CAUTION
Risk of injury and damage
Be aware of the weight of the device during

storage.

ATTENTION
Risk of damage
Short-circuit due to high levels of humidity.
Store the device only in dry indoor rooms.

Care and service

DANGER
Danger of injury
Danger of the device unintentionally start-
ing and danger of electric shock
Switch off the device and unplug the mains
plug before performing any work on the de-
vice.
Note
Observe the local regulations for accident
prevention and the safety instructions.
Dust extraction machines are safety devic-
es for the prevention or elimination of haz-
ards according to the German BGV A1:
 For servicing performed by the user, the
device must be disassembled, cleaned
and maintained only to the degree that
this is possible without presenting a dan-
ger to the maintenance personnel and
other persons. Suitable precautionary
measures include detoxification before
disassembly. Make provisions for local
forced ventilation at the location where
the device is to be disassembled, for
cleaning the maintenance surface and
to ensure adequate protection for the
personnel.
 The exterior of the device should be de-
toxified by vacuuming and wiped clean,
or treated with sealant before being re-
moved from the hazardous area. All unit
parts must be regarded as contaminated
when they are taken from the hazardous
English

Transport

Storage
17