Description Of The Unit; Initial Startup - Kärcher IVS 100/75 M Z22 Betriebsanleitung

The maximum vacuum value in relation to
the hose cross-section is specified on the
label. The actual value can be read on the
pressure gauge. the filter must be cleaned
or replaced is this value is not reached, see
chapter Cleaning the filter. The various dif-
ferent hose cross-sections allow adaptation
to the various different connection cross-
sections of the accessories.
The label specifies the order numbers of
the filters and dust bags approved for use
with this device.
Filter
Dust bag
14
6.907-651.0
6.907-646.0
6.907-336.0
English

Description of the unit

6
5
4
3
2
1
13
Steering rollers with parking brake
1
Sliding handle
2
On/off switch
3
Filter cleaning cover
4
Filter cleaning handle
5
Suction pipe holder
6
Pressure gauge
7
Filter chamber lock
8
Muffler
9
Cable clips
10
Suction hose connection nozzle
11
Vacuum cleaner waste container un-
12
locking lever
Floor nozzle holder
13

Initial startup

For the figures, refer to the graphics page
ATTENTION
Electrical shock in the event of a short-
circuit
Exceeding the mains grid impedance can
cause a short-circuit.
The maximum permissible mains grid im-
pedance at the electrical connection point
(see Technical data) must not be exceeded.
DANGER
Damage to the skin, lungs and eyes
through fine dust
Emission of fine dust when used without a
filter or with a damaged filter
Never vacuum without a filter or with a
damaged filter.
ATTENTION
Damage to the device
The suction motor can be damaged if the
device is used without a filter or with a dam-
aged filter.
Never vacuum without a filter or with a
damaged filter.
7
8
9
10
11
12