Troubleshooting - Hendi 281369 Gebrauchsanweisung

Cleaning and maintenance
• Always remove the plug from the socket be-
fore cleaning the microwave.
• Beware: Never immerse the microwave in
water or any other liquid!
• Clean the outside of the microwave with a
damp cloth and water with mild detergent.
And dry afterwards.
• Clean the inside and door with a damp cloth
and water with mild detergent to remove all
food and grease build up.
• Remove any spillage right after each use. Not
cleaning can result in burnt is stains and bad
smells.
Trouble shooting
The following events can be considered as nor-
mal effects of working with this microwave.
• Radio and TV reception may be interfered
when the microwave is operating.
Trouble
Microwave doesn't
start working
Oven doesn't heat
The display shows
'E-01' or 'E-02'
The display shows
'OVEN IS HOT DO NOT
OPEN THE DOOR' for
item no.: 281369 only.
Light and fan make
noise when the
microwave finished
operating.
Possible cause
Power cord not plugged in
correctly.
Fuse blown of circuit
breaker active.
Power outlet defective
Door not closed correctly
Temperature sensor
broken
Warning is activated by the
high temperature in the
chamber.
High temperatures.
• Keep the sealing gaskets on the door clean,
clean them regularly with a wet cloth and wa-
ter with a mild detergent.
• Never use aggressive cleaning agents or
abrasives. Do not use any sharp or pointed
objects. Do not use petrol or solvents! Clean
with a damp cloth and detergent if necessary.
Do not use abrasive materials.
• Clean the grease and air filter regularly, the
microwave might overheat when this isn't
done properly or food will get contaminated
with grease.
• The light of the oven might be dimmed when
operating.
• During heating steam can come from the
food and can accumulate on the cooler parts
of the microwave like for instance on the
door.
Solution
Check if the power cord is plugged in correctly.
Replace fuse or reset circuit breaker. If not sure how
to do this contact your supplier.
Test outlet with other appliance and check circuit
breaker.
Check the door if it closes properly, if it can't be
closed properly contact your supplier.
Unplug the microwave from the power outlet and wait
10 seconds before plugging the power cord back in.
If the problems isn't solved after this contact your
supplier.
Wait 3 minutes, the microwave will cool down. Check
is the vents are clear. Never use the microwave
without food in it, don't overheat food. If the problem
isn't solved after these steps contact your supplier.
This is normal, the lamp and fan stop when the
microwave has cooled down enough. If they don't stop
working unplug the microwave from the power socket
and wait 10 seconds before plugging back in. If this
doesn't solve the problem contact your supplier.
EN
11