Troubleshooting - Hendi 281369 Gebrauchsanweisung

Trouble shooting
The following events can be considered as normal
effects of working with this microwave.
• Radio and TV reception may be interfered when the
microwave is operating.
Trouble
Microwave doesn't start working
Oven doesn't heat
The display shows 'E-01' or 'E-02'
The display shows 'OVEN IS HOT DO
NOT OPEN THE DOOR'
Light and fan make noise when the
microwave finished operating.
• The light of the oven might be dimmed when op-
erating.
• During heating steam can come from the food and
can accumulate on the cooler parts of the micro-
wave like for instance on the door.
Possible cause
Power cord not plugged in correctly.
Fuse blown of circuit breaker active.
Power outlet defective
Door not closed correctly
Temperature sensor broken
Warning is activated by the high
temperature in the chamber.
High temperatures.
Solution
Check if the power cord is plugged
in correctly.
Replace fuse or reset circuit breaker.
If not sure how to do this contact
your supplier.
Test outlet with other appliance and
check circuit breaker.
Check the door if it closes properly,
if it can't be closed properly contact
your supplier.
Unplug the microwave from the
power outlet and wait 10 seconds
before plugging the power cord back
in. If the problems isn't solved after
this contact your supplier.
Wait 3 minutes, the microwave will
cool down. Check is the vents are
clear. Never use the microwave
without food in it, don't overheat
food. If the problem isn't solved after
these steps contact your supplier.
This is normal, the lamp and fan
stop when the microwave has cooled
down enough. If they don't stop
working unplug the microwave from
the power socket and wait 10 se-
conds before plugging back in. If this
doesn't solve the problem contact
your supplier.
EN
11