Safety Information - KEF PSW4000 Installationshandbuch

SAFETY INFORMATION

TO REDUCE THE RISK OF FIRE OR ELECTRICAL SHOCK, DO NOT EXPOSE
CAUTION
RISK OF
ELECTRIC SHOCK
DO NOT OPEN
CAUTION:
TO REDUCE THE RISK
OF ELECTRIC SHOCK, DO NOT
REMOVE COVER (OR BACK).
NO USER-SERVICEABLE PARTS
INSIDE. REFER SERVICING TO
QUALIFIED SERVICE PERSONNEL.
WARNING:
Due to the mains switch being located on the rear panel, the apparatus must be located in an open area without anything
obstructing access to the mains switch.
FOR UK:
The mains lead is terminated with a moulded three pin plug.
Should the plug on the flexible cord not be of the type for your socket outlets do not use an adaptor but remove the plug from the
cord and discard. Carefully prepare the end of the supply cord and fit a suitable plug.
The fuse must be replaced with one of the same rating.
IMPORTANT
The wires in this mains lead are coloured in accordance with the following code:
Blue:
Brown:
Yellow & Green:
As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the
terminals in your plug, proceed as follows:
The wire which is coloured Blue must be connected to the terminal which is marked by the letter N or coloured Black.
The wire which is coloured Brown must be connected to the terminal which is marked with the letter L or coloured Red.
FOR EUROPE:
A mains lead compatible with national earthing standards and complying with the local safety requirement is supplied.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Warning: Changes or modifications to this unit not expressly approved by
the party responsible for compliance could void the user's authority to
operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is needed.
•
Consult the dealer or an experienced radio/TV technician for help.
WARNING
THIS APPLIANCE TO RAIN OR MOISTURE
Explanation of Graphical Symbols
Neutral
Live
Earth
The lightning flash with arrowhead symbol,
within an equilateral triangle, is intended to
alert the user to the presence of uninsulated
"dangerous voltage" within the product's
enclosure that may be of a sufficient
magnitude to constitute a risk of electrical
shock to persons.
The exclamation mark within an equilateral
triangle is intended to alert the user to the
presence of important operating and
maintenance (servicing) instructions in the
literature accompanying the appliance.
•
A combined mains
power input lead and
country specific mains
plug is provided.
•
Check before connecting
to your local mains
supply that the local
supply voltage is the
same as that marked on
the rear panel. If it is not,
check with your supplier
before proceeding.