CO/Tech 36-6541 Bedienungsanleitung Seite 8

Modes
1. Plug the fan heater into a 230 V socket and set the main power switch (7) on
the back panel to ON.
2. Press the power button (3) on the control panel.
3. The fan heater starts on half power and the display shows:
4. Press (A) and/or (B) once if you want to increase to full power. Press the button
again to switch the fan heater off. Press once again to switch the fan heater
back on. The fan will continue rotating for about 10 seconds after switch-off to
cool the heating elements.
5. Press (F) to start the fan heater oscillating. Press the button once again to stop
the oscillation.
Setting the desired temperature
1. Switch the fan heater on.
2. Press (E) twice. The thermostat setting "88 °C" will flash on the display.
Set the desired room temperature (15–35 °C) using (C) and (D) while
the temperature setting is flashing. The setting will be saved when the temperature
stops flashing.
3. The heating elements will be switched off automatically when the desired room
temperature has been reached. The fan heater will continue to maintain the set
thermostat temperature.
Setting the duration of operation
1. Switch the fan heater on.
2. Press (E) once. The timer setting "88 H" will flash on the display. Set the desired
operating time (1–12 hours) using (C) and (D) while the time setting is flashing.
The setting will be saved when the time stops flashing.
3. The fan heater will switch off automatically after the set time has elapsed.
Overheating protection
The fan heater has two built-in thermal cut-out switches. If the thermal cut-out switch
is triggered, the heating element is automatically shut off. Allow the thermal cut-out
switch to cool for 5 minutes. Start the fan heater again as normal.
Tip-over switch
The fan heater also has a tip-over switch which switches the fan heater off if it
is inclined at an angle. The fan heater can be started again once it is standing
vertically again.
8