Attaching / Removing A Dust Extraction Device; Inserting / Changing Batteries Of The Laser; Operation; Setting The Cutting Depth - Parkside PTS 500 C3 Bedienungs- Und Sicherheitshinweise

NOTE
The power indicator
u
product is connected to the mains.
1. Press the spindle lock button
spindle (see fig. B).
2. Use the provided hex key
clockwise and remove the blade bolt with
washer 18 and locking flange
(see fig. C). The blade bolt
hand thread.
3. Loosen the cutting depth selector with
indicator .
11
4. Press the plunge lock button
swivel the base plate
5. Remove the saw blade
the backing flange.
Follow the above procedure in reverse order
to attach blades. Pay attention to the correct
alignment of the locking flange
Attaching / removing a dust
Q
extraction device
WARNING!
During operation fine dust will be generated!
u
Some dusts are highly inflammable and
explosive! Always attach a dust extraction
device when using this product in order to
keep the working area clean! Wear a dust
mask when operating this product! Dust can
be harmful to health! Especially dust and
chips of wood that has been treated, e.g.
with wood preservative or a stain!
Do not smoke during operation, keep heat
u
sources and open flames out of the working
area!
This product features a designated dust extraction
outlet to connect a vacuum cleaner reducing
14
generated dust during operation on the workpiece
and airborne.
1. Align the slots of the dust extraction hose
with the keys of the dust extraction outlet
slide it over and lock by turning clockwise.
Follow the above procedure in reverse order to
remove the dust extraction hose
16 GB
is lit when the
2
to lock the
15
16
to loosen
19
uses a left-
18
forward and
1
up.
6
. Do not remove
17
.
19
20
,
14
after work.
20
Inserting / changing batteries
Q
of the laser
This product features a laser to guide cuts, which
is powered independently from the product with
batteries.
1. Use a suitable crosshead screwdriver to
loosen and remove the screw from the battery
compartment cover
2. Take off the battery compartment cover
and pull out exhausted batteries if present.
3. Insert new batteries by pushing them in
between the contacts, observing their correct
polarity as marked on the batteries and the
battery compartment.
4. Place the battery compartment cover
onto the battery compartment and secure it
with the screw.

Operation

Q
CAUTION! RISK OF INJURY!
Keep your hands away from the accessory
u
when the product is in operation.

Setting the cutting depth

Q
NOTE
Select a cutting depth of approx. 3 mm
u
more than the thickness of the material. This
ensures that you achieve a clean cut.
1. Loosen the cutting depth selector
desired cutting depth with its indicator on the
cutting depth scale
desired position.

Switching the laser on and off

Q
Switching on:
1. Slide the on / off switch for the laser
the position "ON" to switch the laser on.
Switching off:
2. Slide the on / off switch for the laser
the position "OFF" to switch the laser off.
NOTE
Always remember to switch off the laser after
u
work to avoid draining the batteries.
(see fig. E).
26
26
back
26
, set the
11
and retighten it at the
12
to
24
to
24